Wall Mounting - WarmGlass.com

Wall Mounting

This is the main board for discussing general techniques, tools, and processes for fusing, slumping, and related kiln-forming activities.

Moderators: Tony Smith, Brad Walker

Post Reply
Posts: 9
Joined: Thu Jan 12, 2012 6:05 pm

Wall Mounting

Postby DonnaG » Fri Jun 22, 2012 11:58 am

Sometimes I get carried away with a design and get 3/4 of the way through before I realize I haven't thought it out completely (this has never happened to anyone else, right?). On my worktable at the moment are two mermaids -- each approximately 18" tall and 4 1/2" wide. My poor Taurus 3 is about to mutiny on me after all these fancy curves. However, once I get them fired, I'm not quite sure how to hang them. So far all my work has been panels, bowls, vases, etc. Any suggestions (other than metal rings or drilling holes)? There are just so so many options on the net.
Thanks - Donna

Valerie Adams
Posts: 587
Joined: Mon Apr 19, 2004 2:49 pm
Location: Santa Rosa, California

Re: Wall Mounting

Postby Valerie Adams » Fri Jun 22, 2012 2:42 pm

If there are opal areas to mask them, aluminum Panel Clips are great. They're also called French Cleats, I believe.

Posts: 1079
Joined: Mon May 19, 2003 6:19 pm
Location: Portland, OR

Re: Wall Mounting

Postby Morganica » Fri Jun 22, 2012 7:39 pm

You can also make french cleats out of clear acrylic if your glass is mostly transparent. They'll still show a bit, but are far less obvious.
Cynthia Morgan
Marketeer, Webbist, Glassist

"I wrote, therefore I was." (me)

Post Reply

Return to “Techniques and Tools”

Who is online

Users browsing this forum: Google [Bot] and 28 guests

Warm Glass

2575 Old Glory Road, Suite 700
Suite 700
Clemmons, NC 27012
Phone: (336) 712 8003
Email: wg@warmglass.com