Penny Wise and Pound Foolish - WarmGlass.com

Penny Wise and Pound Foolish

This is the main board for discussing general techniques, tools, and processes for fusing, slumping, and related kiln-forming activities.

Moderators: Tony Smith, Brad Walker

Post Reply
sbaddley
Posts: 11
Joined: Sun Mar 09, 2003 8:53 pm
Location: Smithfield, Ut

Penny Wise and Pound Foolish

Postby sbaddley » Tue Feb 26, 2013 12:00 pm

Was working on a project using my Taurus Ring Saw and the blade broke. After changing the blade, a series of cuts that took a lot of pressure on the blade and about 5 minutes now takes less than a minute and very little pressure on the blade. Who Knew? Guess I should think about changing my grinder head.

Every once in a while I have to call myself out for being too cheap and foolish. :D
Scott B

Nicole Hanna
Posts: 27
Joined: Wed Jul 27, 2005 10:17 am
Location: SW Missouri
Contact:

Re: Penny Wise and Pound Foolish

Postby Nicole Hanna » Tue Feb 26, 2013 3:25 pm

I do the same thing, but those blades are so darn expensive ya just hate to not use it till it finally screams and breaks on ya!

Nicole
When I stand before God at the end of my life, I would hope that I would have not a single bit of talent left and could say, "I used everything you gave me." (erma bombeck)


Post Reply

Return to “Techniques and Tools”

Who is online

Users browsing this forum: No registered users and 35 guests

Warm Glass

2575 Old Glory Road, Suite 700
Suite 700
Clemmons, NC 27012
Phone: (336) 712 8003
Email: wg@warmglass.com