melted mess - WarmGlass.com

melted mess

This is the main board for discussing general techniques, tools, and processes for fusing, slumping, and related kiln-forming activities.

Moderators: Tony Smith, Brad Walker

Post Reply
Michael Stevens
Posts: 67
Joined: Thu Dec 26, 2019 2:52 pm

melted mess

Postby Michael Stevens » Thu Jul 16, 2020 7:49 pm

I was casting something and the mold poured out onto kiln shelf and the heating elements. I have about 6mm thick glass encasing some of the heating coils.

I chisseled off some chunks, but I'm. afraid of doing damage to the kiln if repeatdely pounding. should I heat up to 500 degrees and glass cool it, would that remove the glass better?

Brad Walker
Site Admin
Posts: 1349
Joined: Fri Mar 07, 2003 9:33 pm
Location: North Carolina, USA
Contact:

Re: melted mess

Postby Brad Walker » Thu Jul 16, 2020 8:54 pm

I've had a situation where the glass remained on the coils for years, so that would be my first choice. Do nothing until you eventually need to change the elements.

If anyone else has a better solution, love to hear it.

Michael Stevens
Posts: 67
Joined: Thu Dec 26, 2019 2:52 pm

Re: melted mess

Postby Michael Stevens » Fri Jul 17, 2020 2:33 am

So I removed some of the glass, opened the coils a little and then put back in place. I'm testing it now , if I screwed the coils, I can get replaced for less than 200 dollars, not too bad, . but I'm hopeful this will be ok

jim simmons
Posts: 454
Joined: Sun Mar 09, 2003 10:37 pm
Location: Hillsboro Oregon
Contact:

Re: melted mess

Postby jim simmons » Fri Jul 17, 2020 12:23 pm

Should e just fine, I did exactly what Brad did about 6 years ago and it is working just fine.
The other Jim

Kevin Midgley
Posts: 713
Joined: Mon Mar 10, 2003 11:36 am
Location: Tofino, British Columbia, Canada

Re: melted mess

Postby Kevin Midgley » Sat Jul 18, 2020 1:42 pm

I had glass on elements for years.
If you have some electrical safety controls, turn off, remove power when kiln is heated to say 800F???
With a spray bottle of water dialed to a fine stream, Open the kiln and spray onto the glass which if you are lucky will crack from the thermal shock and become removable.
allow kiln to cool and remove glass carefully.
Repeat as needed but also do at your own risk.


Post Reply

Return to “Techniques and Tools”

Who is online

Users browsing this forum: No registered users and 54 guests

Warm Glass

2575 Old Glory Road, Suite 700
Suite 700
Clemmons, NC 27012
Phone: (336) 712 8003
Email: wg@warmglass.com