Not so long ago, I used to ask my granny to sit in front of my old Soviet kiln, read a book she likes and check the temperature every now and then: "if it drops 5dgrC below 'X' turn it on, if it gets 5dgrC above 'X' turn it off" - and so on for 2-3 hours and then off, relying on insulation and sand around the mould. These were all small pieces, not because I knew annealing but because that kiln was small anyway. ...so granny happily sponsored me with half the money for my Bentrup controller some years later for my present kiln...
Lucho
Surface Issues
Moderator: Brad Walker
-
lucho/lachezar/
- Posts: 15
- Joined: Tue Aug 03, 2004 12:46 pm
- Location: bulgaria
- Contact:
-
orittlandau
- Posts: 37
- Joined: Tue May 09, 2006 8:28 am
- Location: israel
- Contact:
