Most Effective Curing Cycle - WarmGlass.com

Most Effective Curing Cycle

Use this forum for discussion on kiln casting, pate de verre, and related topics.

Moderator: Brad Walker

Post Reply
cemoore
Posts: 31
Joined: Mon Aug 11, 2003 10:19 am
Location: Richmond, VA

Most Effective Curing Cycle

Postby cemoore » Sat May 28, 2016 5:48 pm

I'm a bit unsure as to how long I should cure my molds prior to drying. The application is lost wax, not Pdv or open face. BE recommends wrapping molds in plastic for 24 - 48 hours before drying. My typical mold is 10 inch diameter cylinder by 5 inches tall. I've been curing for 24 hours plastic-wrapped. My objective would be to completely cure and strengthen as much as possible without unnecessarily prolonging start of drying. Thoughts?

Post Reply

Return to “Kiln Casting”

Who is online

Users browsing this forum: No registered users and 4 guests

Warm Glass

2575 Old Glory Road, Suite 700
Suite 700
Clemmons, NC 27012
Phone: (336) 712 8003
Email: wg@warmglass.com