The glue discussion prompts me to mention that I want to glue a fused glass float design on to the front of a mirror - which is quite large 58" x 36" and I intend the design to be a 6" band all the way around the whole design.
The design is such that the mirror can be seen thru float glass, therefore I'm told that UV glue is best for strength and clearness.
UVA curing Glue
Moderators: Brad Walker, Tony Smith
-
- Posts: 151
- Joined: Sun Mar 09, 2003 5:42 pm
- Location: Greensboro NC
- Contact:
Well, that's quite ambitious, I must say. Usually, it's difficult to bond such large pieces effectively. Can be done, I "think", with some sheer determination and patience. If there was any way to conceal the "dots" of glue in inconspicuous places, I would suggest that. When I adhere my mirrors on tile, it is a full coverage. Therefore, a large area is difficult to control. You have to push the bubbles out and move the adhesive completely to the outside edges. Then you must hold or clamp the piece as long as it takes to cure properly. Remember, this whole assembly would have to be exposed to the UV light to cure. My suggestion would be to explore a 2-part optically-clear epoxy that could be hidden at the juncture points. Maybe make the opaque pieces part of the design. Without a "hands-on" with you, it's a little more difficult to address. - Barbara
-
- Posts: 148
- Joined: Tue Mar 11, 2003 12:04 pm
- Location: Houston Tx
- Contact: