Hi Ron,
Thank you for the link.
I copied quite a bit of info. down from there.
Unfortunately, I cannot find out ramping up/down info involving
their controller and cannot even find out who makes the controller
for that kiln.
Sounds like I am out of luck.
Maybe I will look on line and in the archives
for 4 segment general controller information and try to
apply that to running the 4th application, the programmable
application for the Sierra Kiln controller. I have already learned
much thanks to the link you gave me!
Regards,
Ruth Elfering
Ron Coleman, Sierra Kiln controller programming
Moderators: Brad Walker, Tony Smith
-
- Posts: 17
- Joined: Mon Jan 05, 2004 3:15 pm
- Location: Melrose, MN
-
- Posts: 468
- Joined: Sun Mar 09, 2003 3:20 pm
- Location: Columbus, Ohio USA
Hi Ruth
I'll bet good money and say the controller was made by Orton. One of the board sponsors.
This will take you to their listing of current controllers.
http://www.ortonceramic.com/Firing/cont ... ature.html
There is a BooBoo in the links to some of the manual pdf files.
These will get you to the files
Jewelery controller
http://www.ortonceramic.com/Firing/pdf_ ... manual.pdf
Cone fire controller
http://www.ortonceramic.com/Firing/pdf_ ... manual.pdf
Speed controller
http://www.ortonceramic.com/Firing/pdf_ ... manual.pdf
Ramp/hold controller
http://www.ortonceramic.com/Firing/pdf_ ... manual.pdf
Hope this helps
Ron
I'll bet good money and say the controller was made by Orton. One of the board sponsors.
This will take you to their listing of current controllers.
http://www.ortonceramic.com/Firing/cont ... ature.html
There is a BooBoo in the links to some of the manual pdf files.
These will get you to the files
Jewelery controller
http://www.ortonceramic.com/Firing/pdf_ ... manual.pdf
Cone fire controller
http://www.ortonceramic.com/Firing/pdf_ ... manual.pdf
Speed controller
http://www.ortonceramic.com/Firing/pdf_ ... manual.pdf
Ramp/hold controller
http://www.ortonceramic.com/Firing/pdf_ ... manual.pdf
Hope this helps
Ron
-
- Posts: 17
- Joined: Mon Jan 05, 2004 3:15 pm
- Location: Melrose, MN
WOW! Thanks Ron!
Thanks again Ron!
You sure shortened my search time!
Take care!
Ruth!
You sure shortened my search time!
Take care!
Ruth!