I fused together a block of 3/8" strips about 5"X7" as an experiment for a design I'm trying to work out involving cutting the block up, adding another element and fusing it back together. It worked fine except for the look of the lines from the strips. The top of the block is fully fused together, the bottom is as well only I can feel tiny tiny ridges. It's also got a more linear look I like, so I'm going to flip it over and use the bottom as the top.
I was wondering about the tiny ridges though. Any avoidance techniques? I kept the totally fused side up during the second fuse because I wasn't thinking that the bottom wouldn't totally fuse smooth. Also I didn't realize that I'd like the bottom better.
Right now I'm using diamond hand pads to try and get it smooth. My triceps would like to know if this is a job better suited for a sandblaster. Not that I have a set-up, but DH does at his shop that can fit a whole engine block inside, and if he'd just set up the pressure pot I could use it.
Should I; a) go kick his arse in gear, b) look ahead and flip the piece so the bottom becomes the top, c) continue with the hand pads, or d) other?
Fusing strips
Moderators: Brad Walker, Tony Smith
-
- Posts: 126
- Joined: Fri Sep 12, 2003 12:15 pm
- Location: Myrtle Beach
- Contact:
-
- Posts: 475
- Joined: Sun Mar 09, 2003 5:01 pm
- Location: Arizona
- Contact:
-
- Posts: 126
- Joined: Fri Sep 12, 2003 12:15 pm
- Location: Myrtle Beach
- Contact:
-
- Posts: 382
- Joined: Sun Mar 09, 2003 8:10 pm
- Location: Washington DC Metropolitan Area
- Contact:
-
- Posts: 475
- Joined: Sun Mar 09, 2003 5:01 pm
- Location: Arizona
- Contact:
Color dances . . . gee, I like that. I've been trying to think of something to call my inserts - other than "inserts"Barbara Muth wrote:Jackie, my mind just got boggled. Are you saying that your intricate color dances are fired upside down in the initial firing? (or just upside down when you frame them)?
Barbara
Anyway, you can "unboggle" - I fire the color-dances (I'm testing the phrase) face up first and then all subsequent firings are face down.
Jackie
-
- Posts: 382
- Joined: Sun Mar 09, 2003 8:10 pm
- Location: Washington DC Metropolitan Area
- Contact: