Could someone advise me on whether I can use this "honing machine" as a lap grinder. I purchased it CHEAP $150.00, but I don't want to invest in 3-4 magnetic discs if it won't preform for me. Here are the specs:
DAYTON Split phase motor
HP 1/3 RPM 172S 115Volts FLA 6.0 FRS6Z HZ 60 PH1 INS,CR A, Max 40deg. C Duty cont. DP BRG Sleeve. 16 in magnetic disc.
Is there a way I can put a variable speed switch on it? Please advise whether any investment should be made in this. I should say --It does run...seems balanced...Who would you have make necessary updates or alterations?
All comments welcome...Thanks in advance. Kelly Makuch
honing Machine--can it be a lap grinder?
Moderators: Brad Walker, Tony Smith
-
- Posts: 37
- Joined: Tue Mar 11, 2003 10:42 pm
- Location: Connecticut
-
- Posts: 1037
- Joined: Sun Mar 09, 2003 5:59 pm
- Location: Massachusetts, USA
- Contact:
-
- Posts: 37
- Joined: Tue Mar 11, 2003 10:42 pm
- Location: Connecticut
-
- Posts: 1037
- Joined: Sun Mar 09, 2003 5:59 pm
- Location: Massachusetts, USA
- Contact:
A lap wheel is a pretty simple device... a motor, a platen, some bearings and a water feed. The 1/3 HP motor sounds a little small since the larger lap wheels that I've seen are 3/4 HP or larger, but a motor is easy to change. A variable speed motor is a different story and will cost you some $$$. Maybe $300 to $500 by the time you're done with the motor and controller, and I'm not sure of the value. You'd be better off installing a 3/4 HP motor with a reversing switch and run the unit at a constant speed. If the platen is heavy enough to support the weight of a 15" diameter bowl, I'd say you're in good shape to start.
Tony
Tony
The tightrope between being strange and being creative is too narrow to walk without occasionally landing on both sides..." Scott Berkun
-
- Posts: 37
- Joined: Tue Mar 11, 2003 10:42 pm
- Location: Connecticut