Search found 9 matches
- Tue Mar 17, 2015 10:36 pm
- Forum: Techniques and Tools
- Topic: lap grinder repair
- Replies: 4
- Views: 8481
Re: lap grinder repair
Thank you Linn. Will do that tomorrow.
- Tue Mar 17, 2015 5:40 pm
- Forum: Techniques and Tools
- Topic: lap grinder repair
- Replies: 4
- Views: 8481
lap grinder repair
i have an asw 18" lap grinder that is now leaking like a sieve at the inner elbow joint. i have emailed the company many times with no response. since the grinder was pricey i am eager to have it fixed but have no idea who to take it to or if I can fix it myself. any suggestions, please? many t...
- Mon Aug 04, 2014 5:02 pm
- Forum: Jewelry Making
- Topic: a non speed bump pendant???
- Replies: 4
- Views: 48864
Re: a non speed bump pendant???
why thank you. i will certainly give it a try...
- Mon Aug 04, 2014 4:00 pm
- Forum: Jewelry Making
- Topic: a non speed bump pendant???
- Replies: 4
- Views: 48864
Re: a non speed bump pendant???
not quite sure what you mean by layer it with the center. pendants have at least 4 layers but i've always gotten a speed bump. please explain???
- Mon Aug 04, 2014 11:11 am
- Forum: Jewelry Making
- Topic: a non speed bump pendant???
- Replies: 4
- Views: 48864
a non speed bump pendant???
Can anyone give me some insight as to how to create pendants with fiber channels that do not have speed bumps where the channel goes through? The pendant is one level, one smooth, even surface. Forgive me if this has been answered and answered again in previous posts. I could not find it... All the ...
- Thu Aug 14, 2003 2:11 pm
- Forum: Techniques and Tools
- Topic: making holes
- Replies: 10
- Views: 12563
thank you!! will do.starchimes wrote:Try getting your bits at http://www.lopacki.com. The prices are good. Bits last a good while. I can usually get about 50 holes per bit.
Regards,
Andrea
cheryl
- Thu Aug 14, 2003 2:10 pm
- Forum: Techniques and Tools
- Topic: making holes
- Replies: 10
- Views: 12563
- Thu Aug 14, 2003 2:09 pm
- Forum: Techniques and Tools
- Topic: making holes
- Replies: 10
- Views: 12563
I purchased some bits that would not work with my flexible shaft set up. So we bought a cheap $20 drill press stand at Harbor Freight Tools and then adapted it to hold a cordless battery operated a drill. To keep it going steadily we slide a tie wrap over the button because battery operated drills ...
- Thu Aug 14, 2003 11:16 am
- Forum: Techniques and Tools
- Topic: making holes
- Replies: 10
- Views: 12563
making holes
i was using 1/4" grinder bits to make holes in plates so they would accept clock works. the problem being 1 bit equals 3 holes. yikes!!! and i can't figure out how to use a drill press without electrocuting myself. my kingdom for a solution!!