WarmGlass.com

Has anyone used Amaco glass? I found several sample boxes, its all marked COE 90. I use 96. I've done a few firings with the Amaco using a schedule that works for 96 (not mixing the 90 and 96) and so far so good. I suspect this stuff is old.

If the adhesive will stick to a painted surface it might be OK. But if the adhesive instructions say to remove any paint, then it probably won't work.

Rust-Oleum makes a spray paint for this. It gets applied to the back, after firing. Also needs a clear coat after the reflective finish is applied. Read and follow the directions. It doesn't give a mirror-like finish but it does reflect. It also seems to highlight every little imperfection in the gl...

I think I found the answer ... right here on this website. I'll try adjusting my schedule.

https://warmglass.com/what-caused-this-huge-bubble/

I'm sometimes getting a large bubble when fusing this piece, the long dimension is 12 inches. Fired on Papyros, my usual full-fuse program that works fine with smaller pieces, and sometimes works fine with this size. Any ideas what causes this?

I had a similar problem ... Youghiogheny 96, piece was about 10 x 12 inches. After full fuse it seemed not quite flat. It broke in half during a slump fire - sometime during the anneal or cool down - the shape was correct, just in 2 pieces now. Maybe incompatible glass - the top layer is Y96-7937M w...

Mine came from Home Depot, in the tools section. They're marked "Premium Defense." Thinner than gardening gloves. Much thicker than latex or medical gloves - I wouldn't expect these to provide any protection from glass as they're designed to block dirt, bacteria and viruses.

Assuming you have the color touch screen controller ...

First load the program you want to change
Then touch Edit
From here you can touch the value you want to change and it should prompt for the new value.
Remember to save it when you're done.

Hope this helps