WarmGlass.com

I have an MK tile saw. I would like to aim the water more directly on the glass and cutting area instead of using their water feed. I have seen some saws with Loc-Line systems that accomplish this. There was an earlier post which directed people to McMaster-Carr. Looking at the system, I'm not sure ...

Thanks Martyand Lisa. I'll try your suggestions. It's so discouraging to end up with a pile of glass pieces instead of slabs. At least I can say that my garage floor is clean!

Tile Saw Rookie

I just tried cutting two glass slabs with my tile saw and ran into a problem. :( The first slab was about 1 inch thick (consistently) and about 10 inches long. I made one cut just fine. However, the second cut started out fine for about the first 3 inches, then the glass broke off and the blade flex...

Thanks Brock! Good to know I don't have to spend another $60 right away.

Charlotte

Well, I did it! After researching tile saws for months, I finally ordered an MK 101pro from Construction Complete for $774.97. I should get it next week. Can hardly wait. I have a question, though. It comes with a blade for cutting porcelain. Can I use that for now, or do I need to get a blade speci...

I had an interesting thing happen to a piece I just fired. The piece is 15" round, BE black irid on bottom, BE black with mica fired on top. I had blasted a design on the top surface. The design included 6 holes(i.e., I blasted all the way thru the glass) evenly spaced around the rim (approx 1/...