WarmGlass.com

Thank you Morgan-

I will fire lightly and not hold it for too long.
Thank you very much for the lesson!

Take care

HI Linn, Thank you for the suggestion. The colored glass is sitting on top of a clear base and yes there are a couple higher levels because they are stacked. I've never heard of a flip and fuse-is that literally turning the piece over and firing it that way. If you full fuse, would you go up 1460 an...

Hello I am making a 20inch table top. The design is Art deco, and I'd like to keep the lines crisp and straight rather than fully fused and soft. I would like the glass to be primarily smooth as it is to be used as a table. I use Spectrum 96 , not sure if I should Contour fuse or Tack fuse? Any sugg...

Hello,

I want to do 2-3 layers of Opague glass. I use Spectrum 96, I want each layer to be distinct, should I tack fuse or full fuse (i don't want the layers melting into eachother)

What is I use a layer of opal and a transparent?

Thanks much

Thank you Cynthia, I just followed what S76 suggested and it worked the first time. Contour is between a tack and a full fuse. When you say visit your annealing process what part do you think I should adjust? I'm new at all this, I just understand why it changed from cycle to cycle? Thanks Anne Marie

Thank you Don-

I don't mean slump, I just wanted some relief in the project rather than fully fused. I will try again with a temp around 1150 degrees.

Hi there, I had previously used this below schedule to contour a bunch of 6 x 3 pieces and they worked perfectly, and then I did the same schedule for another load and all the pieces completely fused. On my third load I adjusted the schedule to the following and it still completely fused-any thought...

Hi there-

I read somewhere that you can use styrofoam as a mold if you kiln wash it- Could this be true?

thanks!

Thanks for the suggestions. I have a feeling it's some sort of clay covered in a cheap metal glaze. Wish me luck!

What happens if I try and slump over a non SS bowl? have this really cool metal covered bowl but I'm sure it's not stainless, can I try it with out damaging my kiln?