Cutting Saw for jewelry making
Posted: Wed Nov 26, 2003 6:30 pm
Hi everyone!
I have been using a regular tile saw for cutting small glass pieces from a bigger piece.
The bigger piece is about 8 inch.x8 inch. two layer full fuse. The smaller pieces become jewelry.
My problem is that the tile saw is huge, noisy and splashes all over, so I have to use it outside where it is cold and of course the water that runs through the diamond blade is also very cold, making my work time not so enjoyable. At this point I am wonder what kind of saw other people use for this kind of work. Any suggestions?
Thanks in advance.
Isabella
I have been using a regular tile saw for cutting small glass pieces from a bigger piece.
The bigger piece is about 8 inch.x8 inch. two layer full fuse. The smaller pieces become jewelry.
My problem is that the tile saw is huge, noisy and splashes all over, so I have to use it outside where it is cold and of course the water that runs through the diamond blade is also very cold, making my work time not so enjoyable. At this point I am wonder what kind of saw other people use for this kind of work. Any suggestions?
Thanks in advance.
Isabella