Top Loader?- save your knuckles - WarmGlass.com

Top Loader?- save your knuckles

This is the main board for discussing general techniques, tools, and processes for fusing, slumping, and related kiln-forming activities.

Moderators: Tony Smith, Brad Walker

Post Reply
Ed Cantarella
Posts: 155
Joined: Mon Feb 26, 2018 3:49 pm
Location: Highland, Michigan, USA

Top Loader?- save your knuckles

Postby Ed Cantarella » Fri Mar 16, 2018 8:38 pm

I keep seeing the scraped knuckles complaints. This. Use rubber coated wire - haven't dropped one yet.
Easy to steer past the thermocouple - left hand up, right hand down(steering)
Worsk on round or octagon too()due to the rubber coating on the wire) - just keep your hands over the darn circle Louise!.. :mrgreen:
With some thin ones I can set a 7" candle plate into a Paragon Caldera, easy-peasy.
20180316_203206.jpg
HER last words were, "I'm melting, melting . . . " Dissenting opinions generally welcome for comic relief or personal edification. Sometimes both.

Post Reply

Return to “Techniques and Tools”

Who is online

Users browsing this forum: No registered users and 28 guests

Warm Glass

2575 Old Glory Road, Suite 700
Suite 700
Clemmons, NC 27012
Phone: (336) 712 8003
Email: wg@warmglass.com

cron