Controlling my new Bartlet controller

This forum is for questions from newcomers to kiln-forming.

Moderator: Tony Smith

Post Reply
Havi
Posts: 619
Joined: Wed Jul 02, 2003 6:01 am
Location: Israel
Contact:

Controlling my new Bartlet controller

Post by Havi »

Hello everybody,
I hope you are all safe and well. The Corona gave me much more time to spend in my studio, for which I am grateful.
As I mentioned before I had to change my kiln-controller, following the electrician's advice. So far so good. I have a problem using it it, though.
If I make a mistake - and want to go back - to re-write, reservrse the mistake - I do not know how to do it. Example: I wanted to write rate of 56 degrees - but wrote 566 degree. Could not reverse it.... So I started another new programme. I am sure there is a more immediate way to do it - but do not know how.
I know I can read the manual - but thought there might be someone who has the answer under one's sleeve.

Many thanks in advance,
BE SAFE
Havi
Haviva Z
- - - - with a smile :)

"Speed comes from the Devil" - (an Arabic proverb)
Image
http://www.havivaz.com
Eric Bloom
Posts: 7
Joined: Fri May 15, 2020 3:39 pm

Re: Controlling my new Bartlet controller

Post by Eric Bloom »

Assuming you have the color touch screen controller ...

First load the program you want to change
Then touch Edit
From here you can touch the value you want to change and it should prompt for the new value.
Remember to save it when you're done.

Hope this helps
Post Reply