re melt cracked piece

This forum is for questions from newcomers to kiln-forming.

Moderator: Tony Smith

Post Reply
Michael Stevens
Posts: 83
Joined: Thu Dec 26, 2019 2:52 pm

re melt cracked piece

Post by Michael Stevens »

I had a 6mm panel shatter so I lined up the pieces up and put a little frit around the areas that cracked and re melted to. full fuse hold 15 minutes. one thing is crack line is visible, the other thing is after take out of kiln the piece made some slight sound like cracking but there aren't any cracks when observed with polarized light.

should I hold the piece at full. fuse longer, and should I anneal it longer?
Sharol
Posts: 123
Joined: Sun Mar 05, 2006 2:45 pm
Location: Tennessee

Re: re melt cracked piece

Post by Sharol »

If you post your firing schedule and perhaps a photo, it would help in getting you some advice.
Post Reply