Adjusting Your Chicago Tile Saw Part Two

This is the main board for discussing general techniques, tools, and processes for fusing, slumping, and related kiln-forming activities.

Moderators: Brad Walker, Tony Smith

Post Reply
Randy W
Posts: 91
Joined: Sun Mar 09, 2003 6:19 pm
Location: Racine, Wisconsin

Adjusting Your Chicago Tile Saw Part Two

Post by Randy W »

With the saw still unplugged and the guard off, place the square flat on the table as shown and LIGHTLY against the blade.
Image

If it needs adjusting, loosen the two large bolts at each end of the machine
then loosen the allen screws and move the bar side to side at both ends until it's square. First tighten the allen screws, THEN the two large bolts. Then check for squareness. Repeat if necessary.
Image

Randy
Top
Post Reply

Return to “Techniques and Tools”