The water flow wasn't correct on my saw either. The tubes were too far away from the blade.
Remove the screw that holds the " Y " shape piece. Slide the two tubes forward until they are almost touching. Then drill a new hole and re-install a new screw with a nut on the bottom. (I have a small spring clamp holding mine in place cause I'm lazy.)
In any event I just added more water to the sump until the pump had enough pressure to hit the blade. Just curious what your solution was. Seems the tubes are too short.
Randy,
Great post. Thank you very much. What do you use to lubricate the bar slide? Mine is very sticky.
Rob
"Come to the edge. We might fall. Come to the edge. It's too high! Come to the edge! And they came, and he pushed...... and they flew."
-- Christopher Logue
Jack Bowman wrote:Why does the picture cover the text on my screen. Maybe I was sick the day we studied how to get the pix out of the way.
Jack
If you are using an older version of netscape that will happen. I used to have that problem with netscape 4.7. I just upograded to netscape 7.1 and all of thjose problems went away.