Drilling holes in sinks

This is the main board for discussing general techniques, tools, and processes for fusing, slumping, and related kiln-forming activities.

Moderators: Brad Walker, Tony Smith

Post Reply
charlie holden
Posts: 260
Joined: Thu Mar 13, 2003 8:26 pm
Location: Atlanta

Post by charlie holden »

A piano repair guy down the hall from me has his drill press suspended from an overhead frame with linear shafts running through it so he can move it about 6 feet in any direction. He has to be able to drill hundreds of holes in the centers of pianos. He also has a little laser pointer on it that he uses to line up the center of the hole, since he can't stand right next to the bit. All homemade.
Top
Liam
Posts: 90
Joined: Sun Mar 09, 2003 10:25 pm
Location: Houston, TX

Post by Liam »

Your rent must be cheap
Top
Post Reply

Return to “Techniques and Tools”