Workshop/Studio

This is the main board for discussing general techniques, tools, and processes for fusing, slumping, and related kiln-forming activities.

Moderators: Brad Walker, Tony Smith

Post Reply
brookman
Posts: 2
Joined: Mon Feb 05, 2007 8:51 pm
Location: Chandler, AZ
Contact:

Workshop/Studio

Post by brookman »

I am getting ready to move my wife into the house from the garage :-) and would like pictures of your studio/workshop . Her configuration in the garage is functional but ugly.

Thank you for any input!
Morganica
Posts: 1079
Joined: Mon May 19, 2003 6:19 pm
Location: Portland, OR
Contact:

Re: Workshop/Studio

Post by Morganica »

http://www.morganica.com/bloggery/2006/ ... udio-tour/

Wrote that some time ago. I have two studios, inside and out--the above discusses the inside "clean" studio. The outside "dirty" studio is in the garage, where I keep kilns, extra stupplies, and do my moldmaking and coldworking. I wrote a bit about the dirty studio here:

http://www.morganica.com/bloggery/2010/ ... my-studio/
Cynthia Morgan
Marketeer, Webbist, Glassist
http://www.morganica.com/bloggery
http://www.cynthiamorgan.com

"I wrote, therefore I was." (me)
Post Reply