mold to form 2 inch diameter cylinder 9 inches in length

This is the main board for discussing general techniques, tools, and processes for fusing, slumping, and related kiln-forming activities.

Moderators: Brad Walker, Tony Smith

Post Reply
pookie
Posts: 5
Joined: Wed Mar 19, 2003 10:01 pm
Location: lyndonville n.y.

mold to form 2 inch diameter cylinder 9 inches in length

Post by pookie »

anyone know where i can buy a mold to fuse a cylinder 2 inches in diameter 9 or so inches long.probably would be a 2 part. could be 1 part used twice and foiled then soldered?
Top
Ron Coleman
Posts: 468
Joined: Sun Mar 09, 2003 3:20 pm
Location: Columbus, Ohio USA

Post by Ron Coleman »

Look around for a piece of stainless steel pipe. Try a scrap metal yard. You can also form your own mold from a piece of stainless steel sheet.
Top
Post Reply

Return to “Techniques and Tools”