ARTIST MARK/LOGO Q

rodney · Post by **rodney** » Fri Jun 06, 2003 6:59 pm

http://www.lhotsky.cz/dsg/k1/t/tk01.jpg

the link above shows the MAKERS MARK, down in the corner, is this cast in, or stamped, when hot, what would keep the mark from distorting during the slump

thanks
rodney

Ron Coleman · Post by **Ron Coleman** » Fri Jun 06, 2003 7:57 pm

Looks like the mark is on the top surface. It could be low fire enamels or a decal that fires on during the slump.

Ron

Lisa Allen · Post by **Lisa Allen** » Fri Jun 06, 2003 9:55 pm

Looks like it might be sandblasted on.........at least in the pic of that one.

Lisa