After a year and a half of sitting in the yard, waiting for the commission of my dreams, I'm finally ready to finish the inside workings of my new kiln.
It is 42"long, and 30" wide, with 18" depth. The walls are brick, and the lid is M board.
I'd like to find a good source for a controller mechanism, and coils. It will need about 80 amps to run the beast, so its not going to come off someone's shelf.
Any suggestions for competant suppliers is welcome.
Thanks, Jerry
kiln elements,controller, etc
Moderators: Brad Walker, Tony Smith
-
- Posts: 41
- Joined: Sun Mar 30, 2003 11:56 am
- Contact:
-
- Posts: 468
- Joined: Sun Mar 09, 2003 3:20 pm
- Location: Columbus, Ohio USA