flat lap questions

This is the main board for discussing general techniques, tools, and processes for fusing, slumping, and related kiln-forming activities.

Moderators: Brad Walker, Tony Smith

Post Reply
The Hobbyist
Posts: 308
Joined: Sun Mar 09, 2003 7:09 pm
Location: Sun City West (NW Phoenix), AZ
Contact:
Contact The Hobbyist

Post by The Hobbyist »

Thanks everyone for the suggestions and clarifications.

Special thanks to Nita's husband Bill for putting me on the path to Surplus Center on the Internet. They have a huge selection of surplus, new sprockets. I just ordered a #50 chain 40 tooth sprocket with a 1 1/2" bore for only $17. They also had some very nice (115 vac) solenoid valves for 1/4 npt water supply. They should be perfect to turn the spray on when I turn on my various grinders. (only $5/ea.)

All the pieces should be in place by next week so I can start construction.

Jim
"With or without religion, good people can behave well and bad people can do evil; but for good people to do evil—that takes religion. " Steven Weinberg
Top
Post Reply

Return to “Techniques and Tools”