Page 1 of 1
New to fusing - need kiln advice
Posted: Thu Jul 10, 2003 9:32 pm
by rosewyn
Hello, I am new to fusing and am just starting to research kilns. I was looking for some advice on a good medium sized starter kiln and controller. I realize there are a lot of sizes, brands, etc.. so this is a broad question but any advice would be greatly appreciated.
Rosewyn
Posted: Thu Jul 10, 2003 9:48 pm
by Brock
I really don't think it matters. Any recommendation is just going to be someone's personal preference. Do your research and pick a kiln. You will learn THAT kiln well, in time, and be in a better position when, and if, you buy another. Brock
Posted: Fri Jul 11, 2003 10:53 am
by Rob Morey
Give Marty a call at Centre DeVerre. The link is at the top of the page. You will find him to be a great help. Be sure and have a pencil and a note pad ready because he gives you tons of information. Last year I bought 2 kilns from him. I wanted to buy one large one but he talked me out of it, even though it was a $1000 less in his pocket. I trust him a lot.
Good luck
Rob
Posted: Fri Jul 11, 2003 12:35 pm
by charlie
buy one size bigger than you can afford now. you'll outgrow anything, especially your first kiln, very quickly.