Page 1 of 1
Adjusting Your Chicago Tile Saw Part Four
Posted: Thu Aug 28, 2003 4:19 pm
by Randy W
The water flow wasn't correct on my saw either. The tubes were too far away from the blade.
Remove the screw that holds the " Y " shape piece. Slide the two tubes forward until they are almost touching. Then drill a new hole and re-install a new screw with a nut on the bottom. (I have a small spring clamp holding mine in place cause I'm lazy.)
[/img]
http://users.wi.net/~magnum/Saw/7.JPG[img]
Good Luck.
Randy[/img]
Posted: Thu Aug 28, 2003 4:48 pm
by Jack Bowman
Great post in theory, but I can't read it because the picture covers the text. Any ideas?
Jack
Posted: Thu Aug 28, 2003 4:49 pm
by Jack Bowman
The picture also covers my last post.
Jack
Posted: Thu Aug 28, 2003 5:14 pm
by Carolyn Ledbetter
Randy and Jack I CAN read the text in your posts. Great info on alignment. Makes me want to rush out and buy a tile saw. Thanks!
Posted: Thu Aug 28, 2003 5:19 pm
by Jack Bowman
Why does the picture cover the text on my screen. Maybe I was sick the day we studied how to get the pix out of the way.
Jack
Posted: Thu Aug 28, 2003 5:22 pm
by Jack Bowman
In any event I just added more water to the sump until the pump had enough pressure to hit the blade. Just curious what your solution was. Seems the tubes are too short.
Jack
Posted: Thu Aug 28, 2003 7:40 pm
by Rob Morey
Randy,
Great post. Thank you very much. What do you use to lubricate the bar slide? Mine is very sticky.
Rob
Posted: Fri Aug 29, 2003 12:14 am
by Lisa Allen
Rob Morey wrote:Randy,
Great post. Thank you very much. What do you use to lubricate the bar slide? Mine is very sticky.
Rob
I'm not Randy, but I had the same problem and called MK. They recommended WD-40 and mine slides great now.
Lisa
Posted: Fri Aug 29, 2003 8:59 am
by jim simmons
Jack Bowman wrote:Why does the picture cover the text on my screen. Maybe I was sick the day we studied how to get the pix out of the way.
Jack
If you are using an older version of netscape that will happen. I used to have that problem with netscape 4.7. I just upograded to netscape 7.1 and all of thjose problems went away.
Jim
Posted: Fri Aug 29, 2003 9:52 am
by Jack Bowman
Thank you Jim. 4.7 it is.
Jack
