Page 1 of 1
open face casting in reusable clay mold
Posted: Wed Jan 28, 2004 11:36 am
by Paul Tarlow
Any reason not to make a reusable clay mold for shallow, open face casting (no undercuts)?
- Paul
Posted: Wed Jan 28, 2004 3:46 pm
by Lauri Levanto
I have done it several times, to make back reliefs.
The molds tend to be wide, so one must be carefull with drying and firing the mold.
I support the mold on pairs large of kiln brick wedges to
make it level and have enough support area.
In repetive work the separator is a problem.
In full fuse temps it is better to replace the kiln wask
after every fuse. Scaping off from a fine detail mold
is not fun. Instead of kiln wash I use 1-2 ratio
plaster and Al2O3. Maybe 1-4 is enough and parts off easier.
-lauri