Fusing on kiln floor
Posted: Sun Nov 04, 2012 3:46 pm
Ok here goes. I have a coffin kiln with inside wall to wall distance of 25".
My piece is 24" and my kiln shelf is 21 or 22". I was thinking of firing on
Sand or plaster. The distance of the floor from the first coil is an inch
Or so. Is that enough thickness of material i end up using to work. I have
Never attempted this before so i so i'm quite apprehensive about
ruining my kiln or my glass.
My piece is 24" and my kiln shelf is 21 or 22". I was thinking of firing on
Sand or plaster. The distance of the floor from the first coil is an inch
Or so. Is that enough thickness of material i end up using to work. I have
Never attempted this before so i so i'm quite apprehensive about
ruining my kiln or my glass.