Page 1 of 1
Current info on ring saws
Posted: Thu Jan 10, 2013 1:57 pm
by Terry Gallentine
I am thinking about getting a ring saw to cut irregular shapes out of standard thickness System 96. What is the current consensus regarding the saws that are presently on the market?
Thanks,
Terry
Re: Current info on ring saws
Posted: Thu Jan 10, 2013 2:09 pm
by Barb R
I use the Taurus 3 - it works fine for 3mm glass. I've also cut thicker (up to 3 layers) - it's very hard on the blade, but it will do it.
Barb
Re: Current info on ring saws
Posted: Thu Jan 10, 2013 5:52 pm
by bob proulx
I have the Tauras 3, good tool.
Bob
Re: Current info on ring saws
Posted: Thu Jan 10, 2013 6:32 pm
by Morganica
Reviewed the Taurus III several years ago, but the review's still valid:
http://www.morganica.com/bloggery/2007/ ... -ring-saw/
Re: Current info on ring saws
Posted: Wed Jan 23, 2013 12:28 am
by dee
i use the taurus 3 for production, depending on what i'm doing i use either the speed blade - so far the longest lasting - or the mega blade. the standard blade is for single thickness - up to 3mm - only or you can break it - yes, i've broken 2 way back. despite the plastic used, it's held up well for 7 or 8 yrs now.
D