Page 1 of 1
best heavy duty saw for cutting pattern bars
Posted: Sat Apr 13, 2013 12:08 pm
by Blair
I am looking at purchasing a new wet saw for cutting pattern bars. I have used the super slicer on the Tauras 3. The blade broke after not much use so I think it would be nice to have something more durable for my studio. I will also use it for other types of glass project. Also what blade would you recommend for the saw. Thank you for your suggestions.
Re: best heavy duty saw for cutting pattern bars
Posted: Sat Apr 13, 2013 12:30 pm
by Rick Wilton
Shapes or just straight cuts?
A tile saw is the best for straight cuts,
http://www.hisglassworks.com/cart/MK_10 ... WmTP7Ue18E
While a Gemini is good for shapes.
http://www.hisglassworks.com/cart/Gemin ... WmTEbUe18E
Re: best heavy duty saw for cutting pattern bars
Posted: Sat Apr 13, 2013 12:45 pm
by Blair
It would be for straight cuts.
Re: best heavy duty saw for cutting pattern bars
Posted: Sat Apr 13, 2013 12:47 pm
by Blair
Thank you for your suggestions.
Re: best heavy duty saw for cutting pattern bars
Posted: Sat Apr 13, 2013 5:45 pm
by Rick Wilton
You don't however really need to spend $800 to get a tile saw.
There are some 10" saws available for $200 - $300, they aren't as good as the MK but some of them work just fine. The one I have was $300.00 and I've used it regularly for 5 years without issue.
Re: best heavy duty saw for cutting pattern bars
Posted: Sat Apr 13, 2013 7:50 pm
by Blair
Thank you Rick. I do not mind paying a little extra for the MK 100 since it is good product. I found one close by for $650 and it will be delivered to me. I do need to figure out the blades I will be using. I did a little more research online and Clearwater Glass studio said that they use the MK 303 blade, an MK Hot Dog Blade, or a Result Blade with a wheel stiffener. This will hopefully be my only equipment purchase for the year.