decal firing schedule suggestions? THANK YOU for any help
Posted: Sat Sep 26, 2015 3:27 pm
Decal Question...ANY help greatly appreciated
I am using black low fire decals on a small 2 layered glass piece and firing it in my small hot start kiln. The thermostat doesn't give me many options for controlling the firing schedule. I fired the first time using the decal instructions which indicated that the top temperature was 1290 with a 10 minute hold. The extra "stuff" around the decal (trimmed) was still visible. SO the question is...higher temperature? longer hold time?
I'm new to decals, but not to fusing,,,BUT have a little bit of a time issue so ANY help is appreciated...
THANK YOU
I am using black low fire decals on a small 2 layered glass piece and firing it in my small hot start kiln. The thermostat doesn't give me many options for controlling the firing schedule. I fired the first time using the decal instructions which indicated that the top temperature was 1290 with a 10 minute hold. The extra "stuff" around the decal (trimmed) was still visible. SO the question is...higher temperature? longer hold time?
I'm new to decals, but not to fusing,,,BUT have a little bit of a time issue so ANY help is appreciated...
THANK YOU