Page 1 of 1
Pot Melt Bubbles and Pits
Posted: Sat Dec 31, 2016 11:19 am
by Mark Wright
Is there any way to prevent or get rid of the dozens of small bubbles and pits on the surface of a pot melt? After sandblasting and a second fusing it looks better but the pits are still there.
Re: Pot Melt Bubbles and Pits
Posted: Sat Dec 31, 2016 12:27 pm
by The Hobbyist
I always hold my melts at around 1500 F for about 45 min to an hour.
Jim "The Hobbyist"
Re: Pot Melt Bubbles and Pits
Posted: Sat Dec 31, 2016 3:46 pm
by Mark Wright
My program:
1- 250/hr to 1000 hold 15
2- 250/hr to 1100 hold 15
3- 450/hr to 1685 hold 90
4- AFAP to 1520 hold 45
5- AFAP to 900 hold 60
6- 100/hr to 750 hold 15