Controlling my new Bartlet controller
Posted: Thu May 14, 2020 12:32 am
Hello everybody,
I hope you are all safe and well. The Corona gave me much more time to spend in my studio, for which I am grateful.
As I mentioned before I had to change my kiln-controller, following the electrician's advice. So far so good. I have a problem using it it, though.
If I make a mistake - and want to go back - to re-write, reservrse the mistake - I do not know how to do it. Example: I wanted to write rate of 56 degrees - but wrote 566 degree. Could not reverse it.... So I started another new programme. I am sure there is a more immediate way to do it - but do not know how.
I know I can read the manual - but thought there might be someone who has the answer under one's sleeve.
Many thanks in advance,
BE SAFE
Havi
I hope you are all safe and well. The Corona gave me much more time to spend in my studio, for which I am grateful.
As I mentioned before I had to change my kiln-controller, following the electrician's advice. So far so good. I have a problem using it it, though.
If I make a mistake - and want to go back - to re-write, reservrse the mistake - I do not know how to do it. Example: I wanted to write rate of 56 degrees - but wrote 566 degree. Could not reverse it.... So I started another new programme. I am sure there is a more immediate way to do it - but do not know how.
I know I can read the manual - but thought there might be someone who has the answer under one's sleeve.
Many thanks in advance,
BE SAFE
Havi