Using Moldmix 6 on an SLA resin positive
Posted: Sun Dec 04, 2022 2:41 pm
Hello all, new here to the forum.
I am familiar with using MoldMix 6 and wax melt outs for my open faced casting molds. I've been asked to cast an open faced sculpture that was printed in SLA resin. It has no undercuts. Rather that make a wax positive, I am wondering if there is a release agent and process that would allow me to do this cleanly without making a wax positive. Appreciate any advice.
I am familiar with using MoldMix 6 and wax melt outs for my open faced casting molds. I've been asked to cast an open faced sculpture that was printed in SLA resin. It has no undercuts. Rather that make a wax positive, I am wondering if there is a release agent and process that would allow me to do this cleanly without making a wax positive. Appreciate any advice.