How do you tell if all kiln wash is removed?
Posted: Sat Dec 17, 2022 5:14 pm
I acquired some casting molds from someone who over-applied kiln wash. I want to remove it and use boron nitride.
How to tell if it is completely clean? If there is a small trace left, will it prevent the BN from working properly?
I think I have it mostly taken care of (scraper, chopstick, scrubbie, sandpaper, brush). Having trouble around the hole of the holey moley, though. I am itching to go to my dremel and use a light abrasive to go over the surface. I think it would be easier to see if I'm hitting everything evenly and smoothly.
Thoughts, advice?
Kinsey
How to tell if it is completely clean? If there is a small trace left, will it prevent the BN from working properly?
I think I have it mostly taken care of (scraper, chopstick, scrubbie, sandpaper, brush). Having trouble around the hole of the holey moley, though. I am itching to go to my dremel and use a light abrasive to go over the surface. I think it would be easier to see if I'm hitting everything evenly and smoothly.
Thoughts, advice?
Kinsey