honing Machine--can it be a lap grinder?
Posted: Wed Apr 07, 2004 1:27 pm
Could someone advise me on whether I can use this "honing machine" as a lap grinder. I purchased it CHEAP $150.00, but I don't want to invest in 3-4 magnetic discs if it won't preform for me. Here are the specs:
DAYTON Split phase motor
HP 1/3 RPM 172S 115Volts FLA 6.0 FRS6Z HZ 60 PH1 INS,CR A, Max 40deg. C Duty cont. DP BRG Sleeve. 16 in magnetic disc.
Is there a way I can put a variable speed switch on it? Please advise whether any investment should be made in this. I should say --It does run...seems balanced...Who would you have make necessary updates or alterations?
All comments welcome...Thanks in advance. Kelly Makuch
DAYTON Split phase motor
HP 1/3 RPM 172S 115Volts FLA 6.0 FRS6Z HZ 60 PH1 INS,CR A, Max 40deg. C Duty cont. DP BRG Sleeve. 16 in magnetic disc.
Is there a way I can put a variable speed switch on it? Please advise whether any investment should be made in this. I should say --It does run...seems balanced...Who would you have make necessary updates or alterations?
All comments welcome...Thanks in advance. Kelly Makuch