Page 1 of 1
i need a kiln controller
Posted: Sun Apr 27, 2003 2:43 am
by pfunkglass
hey to everyone
im new to this site and i hope maybe i can find a kiln controll for a paragon kiln any help is greatlly appriciated
thank you and email me at
parliamentl100@aol.com
pfunk
Posted: Sun Apr 27, 2003 3:37 am
by Kitty
my Paragon has a Bartlett controller. you can contact them at
http://www.bartinst.com/
Posted: Sun Apr 27, 2003 4:38 am
by watershed
I've been thinking about the Fuji. Check Craftwebs Earthbound suppliers for TTI. They are cheap, though I have not used one yet.
Greg
Plug and Go
Posted: Sun Apr 27, 2003 7:59 am
by Ron Coleman
If you want one to just plug in and go, check this link.
http://www.cdvkiln.com/menuccremo.htm
Ron
Posted: Sun Apr 27, 2003 2:52 pm
by Dani
I thought Marty told us we couldn't "just plug in and go".... I remember thinking about one of those for the big Skutt, but it would still have needed some re-wiring... or some kind of modification. Does anyone remember this thread? Thanks ~ D.